Colours and finishes
The EBS simulated brick and stone buildings can be produced
to fit sympathetically into any location or environment and
are therefore ideally suited to locations where stringent local
planning regulations prevail. A choice of flat or pitched roofs
are also available.
Pitched roofs can also be specified with simulated slate
effect finishes. The provision of a sample of brick, stone
or roof tile – or accurate photographic record enables
EBS to create a close match where required.
In addition to the aesthetically conscious simulated finished,
EBS also offer a durable semi-gloss textured finish to BS4800
or RAL colour references.
EBS simulated brick and stone finishes are not only designed
for aesthetical purposes but also save the client considerable
time and cost over traditional build.
Technical specifications
All housings are permanent yet re-locatable. Dependent upon
size the buildings are provided in either one piece (monolithic)
or sectional configurations.
Walls:
semi-gloss textured housing
A core of V313 / 18mm WBP exterior grade
ply is screwed into a treated quality hardwood base, soffit
and doorframe. The unit is then heavily reinforced inside
and out with glass fibre mat and polyester fire retardent
resin, thus providing a very high degree of strength, rigidity
and weather sealing. The outside is finished with a pigmented
gel-coat application. This offers the exterior a lightly textured
and durable shell finish to a colour of the customer’s
choice.
Walls:
simulated brick / stone housings
Manufactured in the same manner as per
the semi-gloss textured enclosures barring the external gel-coat
application. This is replaced by a further layer of EBS’s
brick effect finish. This also acts as an additional strengthener
and sealer.
Flame
retardancy
Wall construction when tested to BS476
Part 8 exceeds a half-hour fire rating (retention of stability,
integrity and insulation). Fire retardancy (resin) is to BS476
Parts 3.5.6 and 7 surface spread of flame class l.
Roofs
and covers
Flame retadant, heavy duty GRP roofs
and covers with built-in strengthening and insulation are
provided as standard.
Insulation
Standard construction 18mm core can
give a ‘U’ value of 2.0W/m2 deg C. However, this
can be improved on further by using a double skin construction
to ‘U’ values of 0.3W/m2 deg C.
Environmental
protection
Degrees of protection up to IP65 can be achieved in accordance
with BS-EN60529. |
